使用研磨平板研磨要注意的幾個問題

時間：2016/2/25 10:21:41 瀏覽量：1087

使用研磨平板研磨要注意的幾個問題
在研磨平板上研磨工件是個相對細心和繁瑣的工作，正是因?yàn)檫@樣，很多高端零件也是通過這種方法獲得的，例如導彈上的某些零件等。但是研磨時要注意一些問題。

1、要選用好的研磨粉，工作場所要清潔，以免工件表面被刮毛。

2、掌握好研磨的速度和研磨的壓力；對準確度高和形狀復雜的表面，研磨速度應該低一些。研磨壓力大小由工件材料和磨

具材料的性質等因素決定的。研磨壓力為0.15~0.2MPa時研磨效率最高。

3、研磨時，一般先用較大壓力和較低速度進行粗研，幾何形狀基本合格后，再用較小壓力和較高速度精研。

4、選用合適磨具，以免磨具耗損太快。

Several Problems to Be Noticed in Using Grinding Plate

Grinding workpieces on a grinding plate is a relatively careful and cumbersome work. Because of this, many high-end parts are also obtained by this method, such as some parts on missiles. But we should pay attention to some problems when grinding.

1. Choose good abrasive powder and clean the workplace so as not to scratch the surface of the workpiece.

2. Grasp the speed and pressure of grinding well. For the surface with high accuracy and complex shape, the speed of grinding should be lower. The grinding pressure is determined by workpiece material and grinding.

It is determined by the nature of materials and other factors. When the grinding pressure is 0.15-0.2 MPa, the grinding efficiency is the highest.

3. When grinding, roughing is usually carried out at a higher pressure and a lower speed. After the geometry is basically qualified, finishing is carried out at a lower pressure and a higher speed.

4. Choose suitable abrasive tools to avoid abrasive wear and tear too fast.

Company name: botou zhuoyuan mechanical equipment manufacturing co.,LTD
Registered address: jiaohe development zone, botou city, hebei province
Fax number: 0317-8031093
Contact information: 15369812793 (WeChat with the same number)  liansheng chu
Postcode: 062151
Enterprise email:1358827475@qq.com
Account Opening Bank: Botou Branch of Bank of China
Account number: 100399943203
Agricultural bank account number: 6228481739059615270
http://zhuoyuanjixie.com